1-49
$3.49
50+
$2.99
Features
| Brand | 436 |
|---|---|
| SKU | SB-S-064-065 |
| Brand | Best Sub |
| Finish | Glossy |
| Mirror Image | Yes |
| Protective Film | No |
Texprint Sublimation Paper on a Water Bottle with Mug Press
Application Instructions
- Set temperature to 360-400 degrees Fahrenheit.
- Set timer to 60-180 seconds.
- Set Pressure at medium.
- Print a mirror image onto Texprint Paper. Image should be larger than the substrate.
- Wrap the printed image around the water bottle and secure with heat transfer tape.
- If your water bottle is loose within the Mug Press, place a silicone pad around the water bottle.
- Press at 360-400 degrees F for 60-180 seconds with medium pressure
- Remove immediately from press once finished and peel hot. Use caution as water bottle will be very hot.
Texprint Sublimation Paper on a Water Bottle with 3D Vacuum Press
Application Instructions
- Turn the 3D Vacuum Heat press on.
- Set the Temperature to 392 degrees F (200 degrees C) and time to 3:30 minutes.
- Set the heating button so both the top and bottom heating lights are on.
- Print a mirror image onto Texprint Paper. Image should be larger than the substrate.
- Wrap the printed image around the water bottle and secure with heat transfer tape.
- Place the water bottle in a tumbler wrap (SB-S-071) and secure the top.
- Open the 3D vacuum press and connect the clear tube to the lid of the tumbler wrap.
- Press vacuum button
- Press the time button
- Remove immediately once finished and peel hot. Use caution as water bottle will be very hot.
Write Your Own Review
Check items to add to the cart or
